KarmaFX Forum

In FL Studio 6.08, i loaded up the effect version of Karma Synth - and made an input module....i made 2 amp modules, set them both to stereo - then routed the input module into both...i then applied panning to the 2 amps, and sent them to different filters...then i made a new amp module and sent the 'split' signal from the 2 amps into it....and applied some more effects before routing to the output.

I hit play - an no sound came out! i hit stop, and sound came out, namely the tail of the delay. I hit play again and it worked fine.

This happens every time i route an input module into an amp. I need to play, then stop (the sound will start workin the instant i stop it), then play again before it works normally....

sound like it has something to do with the amp trigger...
may be a bug ....Please send me the patch matthew

- KarmaFX

ok as soon as i can

I have this problem to, in this case it's a signal routed from one amp into another. I can also send you the patch in question if you want, Kasper.

ok heres an fxp - i find that when i load up karma in an fx slot and then load the fxp, i need to push play, then stop (a little glitch of sound comes thru) and then play again for it to work properly.

editing the amps declick, trigger and gate options does nothing....

http://www.freefileupload.net/file.php? ... amp-fx.fxp

did u get a look kasper? u seem to have dissapeared

ok u havent disappeared have u any idea what causes this?

bumpity

sorry matthew...I thought I replied to this(?)...I tried but couldn't load the patch for some odd reason. Can you make a new one ?

all u need to do is load up Karma Synth as an effect, then make

Input Module -> Amplifier Module -> Output Module

try it! in FL Studio if u can.

please

When I route an input through an amplifier there is no sound at all!

Works fine when I route it through other components though...

cheers,
f.

frankvg wrote:When I route an input through an amplifier there is no sound at all!

Works fine when I route it through other components though...

cheers,
f.

When trigger is enabled, you need to send a MIDI note before it will allow sound to pass through. Or at least I think so.

thats just the thing - even when gate and trigger are turned off it wont let any sound thru the amp module unless i push play and then stop ....

kasper have u had a chance to try this?

not yet...sorry.

I still have this problem. If i open a basic FX patch, then add an amp module, the only way i can get sound to pass through is sending a midi note-on signal to it.

Could you please fix this? If the amp has gate and trigger turned off shouldnt sound just pass through depending on the value of the amp knob??

Fixed. Will be in v1.05. :
Bugfix: Amplifier would not always pass sound when trigger was off. Fixed. (Thanks Matthew!)

I don't think "gate" has any meaning when trigger is off, right?

great! thanks