Page 1 of 1
Step Sequencer - SNAP!
Posted: 07 Nov 2005 03:24
by matthewjumpsoffbuildings
Is there a way to make the sequencer points snap on 0.00 offset, its getting annoying fiddling with them trying to move them a fraction left/right when all i want to do is move them up/down.
there should be a way to snap eithr lft/rght or up/down. maybe by holding shift for one axis, and ctrl for the other?
Posted: 07 Nov 2005 09:53
by karmafx
Yep, this is fixed in the new version.
Double clicking on the handle centers the offset (equal to 0).
it'll be in next release !
- KarmaFX
Posted: 07 Nov 2005 11:23
by karmafx
oh..and by the way...if you just want to change the amplitude of the steps: don't use the handles !
Just left click anywhere else and drag the mouse...
hth
- KarmaFX
Posted: 07 Nov 2005 11:33
by robenestobenz
This is great news. I really love the step sequencer, and I'm using it a lot in the patch bank I'm doing.
Posted: 08 Nov 2005 02:42
by matthewjumpsoffbuildings
wiked! wat about if you want to change the offset without affecting the amplitude? is there a way to do that?
Posted: 08 Nov 2005 11:39
by karmafx
Sorry, no, not at the moment.
I _could_ make it so that if you hold "shift", it wont affect amplitude.
Posted: 09 Nov 2005 04:27
by matthewjumpsoffbuildings
that would be awesomely handy.
Posted: 22 Nov 2005 14:21
by robenestobenz
karmafx wrote:Sorry, no, not at the moment.
I _could_ make it so that if you hold "shift", it wont affect amplitude.
This would be really useful for detailed step seq work.
Posted: 23 Nov 2005 02:54
by matthewjumpsoffbuildings
for sure
Posted: 23 Nov 2005 10:05
by karmafx
Will be in next release !
Posted: 24 Nov 2005 02:28
by matthewjumpsoffbuildings
wiked
