KarmaFX Forum

Hi there,

Dunno why I thought of this, but it could be quite fun.

Would it be possible to link the amplitude or the output of a generator (for example an audio input) into the input of another control, for example filter cutoff, and also set the ratio of amplitude to the amount it affects the control?

Not sure how useful it would be, although this may make for some sidechaining idea from an outside audio source?

(unless, of course, it's already there )

C

It's already there. Use the envelope follower module, it's grouped in with the modulation components.

also - simplest way to do it is - just route the output of any module to in the knob u want to control.

you can adjust how much the output affects the control by left-click and dragging on the arrow in the middle of the wire.