Hi codenixm !
I've just sent you the patch by email, but with the patch template you
have there it is actually pretty easy to setup. Sorry that my first
screenshot didn't show the wires.
1) First you need to connect the generators to the filter1.
To do this, hold ctrl, left click on the blue titlebar that says "Generator1",
then left click (still holding ctrl) on "Filter1" titlebar.
You should see the wire behind the modules. You may release ctrl now
Do the same for Generator2 and 3.
2) Now you need to wire:
Filter1->Amplifier1->Controller1->Effect1->Effect2->Output.
Do this by again holding ctrl. Click on "Filter1" and then on each of every
of the other modules in the list above and in that order. When you keep
holding ctrl you can wire many modules in series that way.
3) We now need to route the ADSR into Filter1's Cutoff and Amp1 Amp
knobs. Do this by again holding ctrl clicking on the "Modulator1" titlebar
then on the Cutoff knob. Do the same with Amp knob. Finally route
MidiTrig into Cutoff as well.
Thats it. All that is left is tweaking the knobs.
So, the final patch should look something like this:
Hope this helps !
btw: what host are you using ?
- KarmaFX
