FR: right-click 'disconnect'

frankvg · Post by **frankvg** » 22 Jun 2006 09:58

If you click a component this would be handy. Another one would be right-click, choose input:

click: check component
click-drag: replace component

Now we have to do multiple clicking for some rerouting: really unproductive

matthewjumpsoffbuildings · Post by **matthewjumpsoffbuildings** » 22 Jun 2006 19:43

u do kno that right clicking on the arrow of a wire deletes it?

could u clarify - im a little unclear as to what it is u right-clicking and what

right-click, choose input:

click: check component
click-drag: replace component

that is all about ???

frankvg · Post by **frankvg** » 22 Jun 2006 20:04

matthewjumpsoffbuildings wrote:u do kno that right clicking on the arrow of a wire deletes it?

No, I didn't! (What keeps the manual...

But thanks for letting me know.

matthewjumpsoffbuildings wrote:could u clarify - im a little unclear as to what it is u right-clicking and what
right-click, choose input:

click: check component
click-drag: replace component
that is all about ???

Well, the procedure now is that you click a component and it gets selected or deselected. So if you want to change an input you have to disconnect one and then connect an other. Why not be able to 'replace' the component. That is one click less. Therefore I made something up: click-drag. You click AND you move the mouse over the component. But perhaps there are far better suggestions?

Since I am not really proficient with this programming I do lots of connecting and disconnecting just to see what happens.